BILL OF MATERIALS   MP+ Transmitter  Ver 1.4 03/25/03 5:00 PM
---------------------------------------------------------------
TYPE/VALUE        QTY  REFERENCE ID
---------------------------------------------------------------
NOTE: C5, C15 and C19 are not installed
43p bottom of PCB   1  C20
100p                1  C10
470p bottom of PCB  1  C21
10n                 3  C1 C2 C4
100n Axial          1  C11                   
100n Radial         9  C3 C6 C7 C9 C12 C13 C14 C16 C17                     
1u                  1  C8
470uF               1  C18

FT37-43 10T         3  L1    L4    L5 (use 7" #27)
FT37-43 10T:3T      1  L3 (use 7" #27) and (4" #27)
XFMR-BIFILAR 6T     1  L2 (use 8" twisted pair #26)
This Xfrm is the equivalent of 4 FT37-43 toroids stacked and glued
The actual part is 2 large ferrite beads from Fair-Rite that
are pre-glued and ready for winding.

NOTE: R17 is not installed
10 1/4W             1  R16
15 1/4W             1  R13
51                  2  R12 R14
200                 1  R10
330 1/4W            2  R1 R3
470                 3  R4 R7 R11
1k                  1  R5 R6 R15
1k or 500 ohm trim  1  R18 (see instructions)
3k                  2  R8 R9
10k                 1  R2

NOTE: Q4 is not installed
MPN3700 PIN Diode   4  D1 D2 D3 D4
2N3906              1  Q1
2SC1945             1  Q2
MRF517              1  Q3
LT1252              1  U1

NOTE: J5 is not installed
J-3PIN              4  J1 J2 J3 J4

4 Connector housings
12 housing pins (Female)
1 heat sink
1 screw, nut and washer
36 inches #27 magnet wire
8 inches #26 magnet wire Twisted pair